Thursday 24 October 2013

Lend-Lease .45 SMGs



"ArtKom GAU #12132, Secret

On March 31st, 1942, the shooting range at military base #36 conducted a test of American 11.43 mm pistol rounds, after receiving 3 million such rounds from Murmansk. The tests were conducted by the Senior Assistant of the Chief of the 5th Department of ArtKom GAU KA military engineer 2nd grade Ohotnikov N.S. and Assistant of the Chief of the 5th Department of ArtKom GAU KA military engineer 2nd grade Karagodin G.K., following the program outlined in this document.

The purpose of the tests was to establish the condition of the received rounds. Rounds were taken from 10 crates, 100 rounds each. The results were as follows:

1. External inspection of the rounds

300 rounds were visually inspected. The inspection shows that the rounds have scum on the casings, and dirt in the casing base. Some rounds have a stamp, some do not. Most rounds have primers sticking out, but some have primers sunk in very deeply.

The bullets are red brass, the casings are yellow brass, but five rounds (1.7%) had a red metallic casing (probably red brass). Most of the cartridges are produced by Remington (with a stamp on the case "REM-UMC.45ACP), but there are others:

Western: 6 (2%)
WRA Co: 4 (1.4%)
FA-34: 2 (0.7%)
FA-40: 6 (2%)
RA-41: 2 (0.7%)

During visual inspection, the following defects were found:

Dented primer: 6 (2%)
Ragged primer edges: 40 (13.3%)
Impacted primer: 46 (15.3%)
Crooked primer: 10 (3.3%)
Weakly housed bullet, removable by hand: 1 (0.3%)
Total: 103 (34.4%)

II: Testing by firing from a submachinegun

The rounds were fired from a Reising SMG #5073 and Thompson SMG #S-152550. 970 rounds were fired. The following defects were found:

Escaping gases (casing ruptured): 6 (0.6%)
Tough extraction of the casing: 3 (0.3%)
The bullet remains in the barrel (no gunpowder): 2 (0.2%)
Misfire (Reising): 59 (6.1%)
Misfire (Thompson): 4 (0.4%)
Casing stuck on extraction (Reising): 25 (2.6%)

Rounds that failed to fire in the Reising could be fired from the Thompson.

III: Inspection of casings

After firing, 300 casings were examined. The following defects were discovered:
Ruptures around primer: 16 (6%)
Penetrated primer: 6 (2%)
Primer fell out: 2 (0.7%)

Conclusions

1. 11.43 mm rounds that arrived at Murmansk were produced by various companies, and in various years.
2. Many rounds have defects, mainly of the primer, which results in escaping gases, rupture of the casing, misfires, poor extraction, and other anomalies.
3. The received shipment of rounds can only be used after removing 100% of defective items, and even that will not stop escaping gases and bullets getting stuck in the barrel.

<Signatures>"

2 comments:

  1. so basically they were shipped by United Parcel Smashers (UPS)?

    ReplyDelete
    Replies
    1. No, the tests show an enormous percentage of clearly defective rounds - possibly rejected batches, if not outright sabotage. You can't reproduce most, if any of these defects by rough shipping.

      Delete

Note: only a member of this blog may post a comment.